Assembly 29
MAN0476 (Rev. 2/10/2006)
SAFETY SHIELDING INSTALLATION
Chain Shielding Installation (Optional)
Full chain, rubber, or steel band shielding,
designed to reduce the possibility of thrown
objects, must be installed when operating in popu-
lated areas or other areas where thrown objects
could injure people or damage property. If this
machine is not equipped with full chain, rubber, or
steel band shielding, operation must be stopped
when anyone comes within several hundred feet.
The optional chain shielding assemblies are ready for
installation when you receive them.
Refer to Front & Rear Chain Shielding, page 37 and
attach as shown by inserting the bolts from inside the
cutter frame out through the shielding. Install hardware
as shown in the parts drawing.
Rubber Deflector Installation (Optional)
Attach rubber deflector (1) and links (2 and 3) to front of
cutter using carriage bolts (4) and flange lock nuts (5).
Figure 25. Optional Rubber Deflector Installation
1. Rubber shield
2. Outside link
3. Center link
4. Carriage bolt
5. 3/8 NC Flange lock nut
To Next Page
Loading...
