4 5
1
Usage
Thishelmethasbeendesignedexclusivelyfor
head protection while riding a bike, skateboard-
ing or roller skating� It may not be used for
other sports or when riding a motorcycle�
2
The right size
Maximum protection is only possible with
thecorrectsizehelmetthatiswelltted.
A
Measure your child’s head circumference
above the ears and eyebrows� Select the correct
sizeforyourchildbasedonthespecications
of the helmet, use the adjustment dial to open
the size adjustment system as wide as it goes,
then place the helmet on your child’s head�
B
If the helmet is too loose, swap the pads
for the thicker version� Only once the hel-
mettsaswellaspossiblewiththeright
padsshouldtheneadjustmentbecarried
out with the adjustment dial on the back�
C
Turntheadjustmentdialuntilthe
helmetsitsrmlybutisstillcomfortable.
3
The right t
Thehelmetshouldcovertheheadwellandsit
horizontally (see illustration)� It should not pull
too far back� It should also not fall so far for-
wardthatitrestrictssight.Tocheckthesizeand
t,openthechinclosureandhaveyourchild
shake their head� If the helmet moves too much,
turntheadjustmentdialtotightenthet.
4
Adjustment of the chin strap
Beforeusingthehelmetforthersttime,adjust
thechinstraplengthtoenablearmyetcomfort-
ablet.Toadjustthelengthofthechinstrap,pull
These instructions contain information about safe use of this
helmet. Please read these instructions before using the helmet
for the rst time and keep them safe.
the strap out of the chin pad and slip the rubber
ringothebuckle.Adjustthelengthasneeded
by pulling the strap, then put the rubber ring back
into its position on the buckle (see illustration) and
thread the end of the strap back into and through
the chin pad� Make sure that the closure never
rests on the chin while the helmet is being used�
5
Operating the Fidlock® magnetic closure
Thishelmetisequippedwithamagneticclosure
by Fidlock
®
� It is easy to use with one hand, even
when wearing gloves� It also minimises the danger
ofpinchingskinorhair.Toopentheclosure,
push the outer section forward in the direction of
thearrow(seeillustration).Toclose,simplyplace
theoutersectionontheothersection.Themagnet
ensures that the two sections snap together�
Proper care
Aggressive cleaning agents and solvents can corrode
the helmet material and compromise the protective
eect.Forthisreason,thehelmetanditscomponents
should only be cleaned with lukewarm water and a
mildsoapsolution.Thehelmetpadscanberemoved
and machine washed at 30 °C or hand washed with
mild detergent then dried at room temperature�
Lifespan
Thehelmetanditscomponentsaresubjecttoanat-
uralageingprocessthatisinuencedbyusageand
storageofthehelmet.Thereforepleaseonlystore
the helmet in a dry location that is protected against
strong sunlight and weathering� We recommend
replacing the helmet with a new model at the latest
afterthreetoveyears.
WARNING
• Toprovidemaximumprotectionthe
helmetmusttwell,allsafetystrapsmust
be taut, and closures closed�
• Thishelmetshouldnotbeusedfor
climbing or other activities in which there
is a danger of strangulation due to
getting caught with the helmet�
• Thishelmetisdesignedtoabsorbtheenergy
of a severe blow; this may lead to partial
destruction of the shell� Even if there is no
visible damage, the helmet should be replaced
immediately after such an impact�
• No helmet can protect against all accidents
or resulting injuries or death� However, if used
correctly,itcansignicantlyreducetherisk
of injury in case of impacts or collisions�
• Theprotectiveeectofthehelmetcanbe
seriously compromised by exposure to varnish,
cleaninguidsorothersolvents.Therefore
please only use lukewarm water, soft cloths
and solvent-free cleaners to clean the helmet�
• Do not make alterations to the helmet with
paints or varnishes, and do not remove or
change any original parts� Also avoid making
additions to the helmet as this could reduce
theprotectiveeect.
• Thehelmetshouldundernocircumstances
be exposed to temperatures over 50 °C
or under -20 °C, as this could impact the
protective function�
• Thehelmetshouldberegularlychecked
for visible defects� Small surface scratches
resulting from normal use do not reduce
theprotectiveeect.
• Please always check that the chin strap is
closed before starting to ride�
Warranty
woomoersa24monthguaranteeonthehelmet,
from the day of purchase, for material and manufac-
turingdefects.Thisguaranteedoesnotextendtonor-
mal signs of use or wear, or damages that occur due
to improper use� A copy of your receipt, with purchase
date, is required to check the validity of guarantee
claims.Theguaranteeisvalidworldwide.Legal
warrantyrightsremainunaectedbytheguarantee.
Service and contact
Thishelmetisatestedbrandproduct.If,de-
spite this, you become aware of a defect or
workmanship problem, please promptly con-
tact us or your dealer to make a complaint�
Contact details can be found on the
back of these instructions for use�
Technical specications
Model: Kids' Helmet
Sizes: XS (46–50 cm), S (50–53 cm), M (53–56 cm)
Material: Outer shell polycarbonate (PC)
Inner shell expanded polystyrene (EPS)
Our helmets comply with the European standard
EN 1078 and the EU regulation 2016/425.
TheEUdeclarationofconformitycan
be found on woombikes�com�
Inspection body:
TÜVRheinlandLGAProductsGmbH
Tillystraße2
90431 Nürnberg, Germany
NotiedunderNo.0197totheECCommission
TheoriginalinstructionsareinGerman.Theseinstruc-
tions have been written to the best of our knowledge�
However, woom GmbH assumes no responsibility for
the completeness and correctness of the information�
EN