PROGRAMMABLE SETTINGS
ADJUSTING TIMES & TEMPERATURES
2. After 5 seconds the Digistat will start controlling at the
selected set point but now displays actual room temperature.
Two chevrons indicates override mode.
3. To exit override press > once or wait until next change in the
pre-set program (i.e. when period 5, in this case, becomes
period 6).
To set a constant room temperature
(Manual mode):
1. Press < once, the display shows temperature flashing (e.g.
20°C).
2. Press + or - buttons to adjust the temperature as required.
The temperature will stop flashing after 5 seconds and start
controlling at this temperature.
3. Press > once, to return to auto mode.
To set holiday mode:
1. Press < twice, the display shows time flashing.
Time periods between 1 to 23(Hr) hours and 1 to 199(d) days
can be set.
2. Press + or - buttons to adjust the count down time as
required.
2 chevrons
indicate override mode
Reverts to 1
chevron
To Next Page
Loading...
