Setting the clock and time
1. Press the set? button until SET and CLOCK are
shown in the display.
2. Press OK to display 24hr and ON.
3. Press + to switch between 24hr and 12hr
display.
4. Decide between 24 hour or 12 hour display and
press set? to select, now the hours will flash.
5. Press + or - to set the correct hour.
NOTE: Speed up the display by holding down
the + or - buttons.
6. When the correct hour has been selected, press
set? to select, now the minutes will flash.
7. Press + or - to set the correct minutes.
8. When the correct minutes have been set, press
set? to select that setting.
Now SET and DATE will be displayed.
If the day and date needs resetting, refer to the
next page for SETTING THE DATE.
If the day and date are correct, press set? to
return to the normal display.
DT20RF RECEIVER
PROGRAMMABLE SETTINGS
OPERATING & INSTALLATION
INSTRUCTIONS
DT20RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 495a (02.2009)
18
To Next Page
Loading...
Need help?
General