Worcester Greenstar Danesmoor Utility Regular ErP+ 12/18 User Manual

UK
User Instructions
Floor standing oil fired condensing boiler conventional flue and room sealed flue
Greenstar Danesmoor Utility Regular
ErP+
and
Utility System
ErP+
12/18, 18/25 & 25/32
6720809783-00.1Wo
For fully pumped open vent and sealed central heating systems and domestic hot water cylinders.
For use with Kerosene (Class C2) only.
6 720 821 721 (2018/04)

Worcester Greenstar Danesmoor Utility Regular ErP+ 12/18 Specifications

General

Model	Greenstar Danesmoor Utility Regular ErP+ 12/18
Category	Boiler
Output	12-18 kW
Fuel Type	Oil
Efficiency Rating	ErP+
Boiler Type	Regular
Mounting	Floor Standing
Brand	Worcester
Dimensions	855mm (H) x 370mm (W) x 600mm (D)

Summary

Preface

Please read these instructions carefully

Important advice for safe and correct use of the appliance.

Dedicated to heating comfort

Highlights the quality and energy efficiency of the Greenstar range.

Key to symbols and safety instructions

1.1 Key to symbols

Explanation of symbols used in the document for warnings and important information.

1.2 Safety instructions

Crucial safety guidelines for operating the boiler and handling potential hazards like oil fumes.

General Information

2.1 Energy efficiency

Information on energy efficiency is provided in the Installation, Commissioning and Servicing Instructions.

2.2 Servicing

Guidelines for regular servicing by a competent engineer and use of original spares.

2.3 User caution

Warning against unauthorized interference with the appliance.

Using your boiler

3.1 Controls

Identifies and describes the main controls and buttons on the boiler's front panel.

3.2 Operating the boiler

Steps for switching the boiler on/off, adjusting temperature, and controlling central heating.

Maintenance

4.1 Maintaining your boiler

Advice on regular checks, servicing, and tips for maintaining boiler performance.

4.2 Servicing

Requirements for annual servicing by a qualified engineer and importance of the Service Record.

External filling loop (sealed system only)

External filling loop (sealed system only)

Instructions for checking system pressure and re-pressurising using the external filling loop.

General information

6.1 Ventilation information

Details on boiler location requirements and ventilation for air circulation and combustion.

6.2 Maintenance clearances

Specifies the minimum clearances around the boiler for servicing and ventilation.

6.3 General notes

Advice on central heating system operation, condensate disposal, room thermostat, and radiator valves.

Fault finding

Fault finding

Troubleshooting common problems with desired temperature, heating duration, and hot water temperature.

7.1 Fault conditions

Describes normal operation, lockout conditions, and how to access reset buttons.

Fault or Breakdown

Fault or Breakdown

Guidance on what to check before calling a service engineer and how to access the boiler data label.

Energy saving

9.1 Tips on energy saving

Practical advice on saving energy through room thermostats, control systems, radiators, insulation, and draught proofing.

Your guarantee

Your guarantee

Details the terms and conditions of the appliance guarantee and how to register it.

Environment/disposal

Environment/disposal

Information on the company's commitment to environmental protection and packaging recycling.