Worcester Greenstar Si Compact Series

12
CONTROLS
Greenstar Si Compact – 6 720 807 278 (2013/05)
3.1.9 BOILER ALERT STATE
In the event of an alert, a fault code and an alert symbol will be displayed on the boiler display, and the blue operation/fault
light will flash. Refer to the Fault finding section on page 18 or press to clear the problem.
3.1.10 BOILER RESET
1. To reset the boiler, press .
2. “Reset” and are briefly displayed.
▶ If the reset was successful the boiler will return to normal operation.
▶ If the reset was not successful then the alert code will be displayed again, and the blue operation/fault light will continue to flash.
3.1.11 TURN OFF THE OPERATION/FAULT DIAGNOSTIC LIGHT (BLUE)
Your new Greenstar boiler is designed to use as little electricity as possible during operation and in stand-by mode. To further
enhance your energy saving during stand-by, you may choose to deactivate the operation/fault diagnostic light. The light will still
flash to alert you to a possible fault, but will not activate during a demand for heat. Please ask your installer to set-up this feature.
If the fault remains and cannot be cleared by pressing the reset button, contact Worcester, Bosch Group for
assistance on 0844 892 3000.
reset
max
min
2
3
1
04
bar
1
ok
eco
reset
e
max
min
°C
°F
227
°C
°F
227
6720643358-14.1Wo
reset
max
min
2
3
1
04
bar
1
ok
eco
reset
e
max
min
°C
°F
Reset
6720643358-09.2Wo
°C
°F
Reset
1.
2.