LM-2 Bi-directional DMX / USB interface EN
4. TROUBLESHOOTING:
Windows
Note: Remember to install the drivers before connecting the LM-2 to your computer.
If after the installation the LM-2 is not working, follow these steps:
1. Connect the LM-2 to an USB port in the computer.
2. Open the Computer Management window (Control Panel – Management Tools) and select the
Device Manager
3. Expand the Universal Serial Bus Controllers (USB) section and find the entry that corresponds to the
LM-2. This entry is the one that dissapears when the LM-2 is disconnected from the USB.
4. Select this entry in the Device Manager and uninstall it (right button, unisntall)
5. Disconnect the LM-2 from your computer and install the drivers again, as explained in chapter
3.Installation.
LM-2 User Manual / Manual de Usuario Pag5
To Next Page
Loading...
Need help?
General