2.7 Initialization2.5 Chase Direction
2.6 Cross and Normal Dimmer
2. Operation Guide2. Operation Guide
9 10
Keep pressing F button, tap button to select
chase direction, the Segment Display shows
"L--" or "R--". "L--" indicates the programs will
chase from left to right, and "R--" indicates the
programs will chase from right to left.
CAO
NOA
in
Keep pressing F button, tap D/S button to select
dimmer mode from Cross / Normal dimmer.
The Segment Display shows "CRO" when cross
dimmer is active. In Cross mode, if output level is
50% or more, the fixture will be fully on; if output
is less than 50%, the fixture will be fully off.
The Segment Display shows "NOR" when normal
dimmer is active. In Normal mode, output level
varies according to manual control.
Press F, Signal Select and Reset buttons
at a time, this unit will initialize its memory,
the Segment Display shows "888". Release
all three buttons, this unit will return to default
setting, the Segment Display shows "IN", and
Manual Dimmer LED lights.
To Next Page
Loading...