Why my Work Pro WG505E/ Vac does not operate?
If your Work Pro Blower/Vac is not operating, first ensure that the blower/vacuum tube is securely attached to the motor housing. Also, verify that the power cord is properly connected to a functioning power source.
What to do if my Work Pro WG505E/ Vac jammed or clogged?
If your Work Pro Blower/Vac is jammed or clogged, there might be debris blocking the impeller, the blower/vacuum tube, or the connection to the leaf collection bag. Clear any clogged debris from these areas to resolve the issue.
Read instructions, be familiar with controls, and use the machine correctly.
Wear appropriate footwear and clothing, use eye/ear protection, and ensure a stable work surface.
Keep fasteners tight, check debris collector, replace worn parts, and use genuine replacements.
Store in a dry, cool place away from children; allow to cool before storing.
Suggests using a residual current device (RCD) with a tripping current of not more than 30mA.
Explains common symbols related to manual, safety, and warnings.
Detailed list of parts included with the blower/vacuum machine.
Presents vibration and noise level information for the tool.
Information and recommendation for purchasing accessories.
Steps for assembling the unit and operating in blower and vacuum modes.
Identifies common problems, their causes, and corrective actions.
Instructions for replacing the plug in the UK and Ireland.
Manufacturer's statement of compliance with relevant EU directives.
To Next Page
General