Workhorse ATV 2507 - User Manual

— GENERAL INFORMATION
— WARRANTY / PARTS / SERVICE
25 GALLON DELUXE ATV SPRAYER - 7 NOZZLE
ATV 2507
— ASSEMBLY
Tools required:
1 – 7/16” End Wrench
2 – 1/2” End Wrenches
1 – Thread Sealant
The purpose of this manual is to assist you in assembling,
operating and maintaining your lawn and garden sprayer.
Please read it carefully as it furnishes information which
will help you achieve years of dependable trouble-free
operation.
Products are warranted for one year from date of purchase
against manufacturer or workmanship defects.
Your authorized dealer is the best source of replacement
parts and service. To obtain prompt, efficient service,
always remember to give the following information:
1. Correct part description and part number.
2. Model number of your sprayer.
Part description and part numbers can be obtained from the
illustrated parts list section of this manual.
Whenever you need parts or repair service, contact your
distributor / dealer first. For warranty work always take your
original sales slip, or other evidence of purchase date, to
your distributor / dealer.
Polyethylene Tank
12 Volt Diaphram Pump
2.0 G.P.M.
Lever Handgun
15 Ft. of 3/8” Hose (handgun)
Pressure Gauge
Adjustable Pressure range (0-60 PSI Max.)
7 Nozzle Fold Out Boom
Quick Detach Spray Boom Feature
Assembly / Operation Instructions / Parts
PRECISION SPRAY EQUIPMENT
®
, a divison of Green Leaf, Inc. 9490 N BALDWIN ST FONTANET, IN 47851 www.workhorsesprayers.com 800-654-9808
a division of Green Leaf, Inc ®
PRECISION SPRAY EQUIPMENT
PSE
®
®
WORKHORSE
WORKHORSE
S P R A Y E R S
by PSE®, a Division of Green Leaf, Inc®by PSE®, a Division of Green Leaf, Inc®
®

Summary

Sprayer Operation

Sprayer Calibration Guide

Spray Tip Rate Chart

Presents data for calculating application rates based on pressure, speed, and spacing.

PowerFLO 7800 Pump Specifications

Pump Motor and Pump Specifications

Detailed specifications for the pump motor and the pump itself, including materials and capabilities.

Pump Installation and Operation Precautions

Important safety and operational advice for installing and using the pump.

Pressure Sensing Demand Switch Function

Explanation of how the pressure sensing demand switch controls pump operation.

Adjusting the Pressure Switch

Instructions on how to adjust the pressure switch for optimal pump performance.

Troubleshooting Common Issues

Troubleshooting: Pump Will Not Start

Identifies causes and solutions when the pump fails to start.

Troubleshooting: Pump Will Not Prime

Addresses issues where the pump runs but does not discharge fluid.

Troubleshooting: Pump Will Not Shut Off

Diagnoses reasons why the pump fails to stop when the output is closed.

Troubleshooting: Leaks from Pump Head or Switch

Guides on identifying and fixing leaks originating from the pump head or switch.

Adjusting System Pressure

Optimal Operating Pressure Settings

Troubleshooting: Pump Restart Issues

Lists checks for a pump that has stopped and will not restart.

Troubleshooting: Low or No Flow

Diagnoses common causes for low or no fluid flow from the sprayer.

Pump Pressure Adjustment Screw

Troubleshooting: Fuse Blowing

Identifies common reasons why the fuse blows each time the pump is activated.

Pressure Gauge Reading vs. Shut-off Pressure

Addresses a pressure gauge reading higher than the set shut-off pressure.

Troubleshooting: Pump Surge When Not Spraying

Diagnoses why the pump might surge or run continuously when not in use.

Wiring Harness Safety Warning

Workhorse ATV 2507 Specifications

General

Power Source	Electric
Max Pressure	3000 PSI
Type	Airless
Motor	0.5 HP
Tip Size	0.015 in