To Next PageTo Next Page
Need help?Do you have a question about the Workhorse ATV 2522 and is the answer not in the manual?
Provides spray rate data based on pressure, speed, and tip selection.
Helps determine the time required to travel distances at various speeds.
Steps for installing the gauge, lead wire assembly, and connecting power.
Attaching ATV mount and helix lever to the tank bottom with screws.
Inserting angle brackets into ATV mounts.
Assembling spray boom, clamps, fittings, check valves, and spray tips.
Warning about checking ATV load rating and safe operation to prevent accidents.
Step-by-step guide on how to lay and secure the ratchet strap to the ATV rack.
List of parts for the pump and valve assembly with stock numbers.
Instructions on how to adjust pressure for boom or wand operation.
Description of the valve function for controlling boom spray.
Details on motor, pump type, materials, and certifications.
Graph showing pump motor temperature rise over time.
Explanation of how the pump's pressure switch controls operation.
Guide on how to adjust the pressure switch for optimal pump performance.
Recommendations for routine pump maintenance and diaphragm replacement.
Safety procedures for returning the pump for warranty or repair.
Lists common issues like pump not starting or not priming with their causes and solutions.
Explains why the pump runs only when flow is detected.
Addresses pump surging issues related to spray wand adjustment.
Guidance on adjusting spray pressure using the by-pass valve.
Defines the ideal operating pressure range for the sprayer.
Information on expected pressure gauge readings during operation.
Specifies the recommended tire pressure for the sprayer.
Troubleshooting steps if the pump fails to restart.
Diagnosing and resolving issues with low or no fluid flow.
Information about the location and types of fuses used in the sprayer.
Specifies the correct amperage for replacement fuses.
Details the maximum spraying distance of the wand.
Instructions on how to properly clean the sprayer tank after use.
Confirms the presence of a pressure adjustment screw on the pump.
Procedure for removing and replacing fuses in the sprayer system.
Information on replacing spray tips with different types.
Troubleshooting common causes for the fuse blowing when the pump is turned on.
Details the warranty period for various sprayer components.
Addresses pressure gauge readings and pump shut-off points.
Troubleshooting why the pump runs continuously or surges when not spraying.
General| Brand | Workhorse |
|---|---|
| Model | ATV 2522 |
| Category | Paint Sprayer |
| Language | English |
