ADDITIONAL SAFETY INSTRUCTIONS
Wear ear protectors.
Exposure to noise can cause hearing loss.
Loss of control can cause personal injury.
• If possible, always use clamps or a vice to hold your work piece.
• Always switch off before you put the tool down.
• Ensure that the lighting is adequate.
• Do not put pressure on the tool, such that it slows the motor down.
• Keep the area free of tripping hazards.
• Do not let anyone under 18 years operate this tool.
• Only use accessories in good condition.
• Do not touch the blade after operation. It will be very hot.
• Keep your hands away from under the workpiece.
• Never use your hands to remove sawdust, chips or waste close by the blade.
• Rags, cloths, cord, string and the like should never be left around the work area.
• Support the work properly.
• If you are interrupted when operating the tool, complete the process and switch off before
looking up.
• Periodically check that all nuts, bolts and other fixings are properly tightened.
• When using the tool, use safety equipment including safety glasses or shield, ear defenders,
and protective clothing including safety gloves.
Wear a dust mask if the cutting or sanding operation creates dust.
If in doubt, do not plug in the tool. Using a power source with a voltage less than the name-
plate rating is harmful to the motor.
The tool must be used only for its prescribed purpose. Any use other than those mentioned
in this Manual will be considered a case of misuse. The user and not the manufacturer shall
be liable for any damage or injury resulting from such cases of misuse.
To use this tool properly, you must observe the safety regulations, the assembly instructions
and the operating instructions to be found in this Manual. All persons who use and service
the machine have to be acquainted with this Manual and must be informed about its poten-
tial hazards.
Children and frail people must not use this tool. Children should be supervised at all times if
they are in the area in which the tool is being used. It is also imperative that you observe the
accident prevention regulations in force in your area. The same applies for general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes made to the tool nor for any damage
resulting from such changes. Even when the tool is used as prescribed it is not possible to
eliminate all residual risk factors. The following hazards may arise in connection with the
tool’s construction and design:
Damage to the lungs if an effective dust mask is not worn.
Damage to hearing if effective ear defenders are not worn
5
To Next Page
Loading...
