Workrite Ergonomics Sierra Series User Manual

#1500152-Rev B Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Sierra Series Workcenters
Special Settings
Before continuing, initialize legs if you have not done so already
After all the legs and the switch are connected and the power cord has been plugged in, hold the
down arrow on the switch until the legs make a short motion down and then back up.
This initializes and synchronizes the table legs.
or
+
2
3
1
5
10
15
20
25
3035
40
45
50
55
60
You must complete
this initialization
step or your table
will NOT function
properly.
Hold down until
table moves
slightly upwards.
Change display from inches to centimeters
Simultaneously press 1 & 2 and the Up or Down Arrow until the readout changes to show S5.
Press the “SET” button with a ballpoint pen (NOT paperclip) to change from inches to centimeters.
To return to inches, repeat the same process.
a
b
or
+
2
3
1
5
10
15
20
25
3035
40
45
50
55
60
a b

Workrite Ergonomics Sierra Series Specifications

General

Brand	Workrite Ergonomics
Model	Sierra Series
Category	Indoor Furnishing
Language	English

Summary

Table Leg Initialization

Initialize Legs

Hold the down arrow until legs move down and back up to initialize and synchronize.

Display Unit Conversion

Change Display to Centimeters

Press specific buttons and the SET button to switch between inches and centimeters.

Digital Height Calibration

Adjust Starting Digital Height Readout

Calibrate the height display for custom worksurface thicknesses by measuring and entering the correct height.

Table Locking Feature

Lock and Unlock Table

Learn how to lock the table to prevent movement and unlock it using a default code.

Custom Height Limits

Set or Delete Lower Height Limit

Define a custom lower height boundary by moving the table and pressing specific buttons.

Set or Delete Upper Height Limit

Define a custom upper height boundary by moving the table and pressing specific buttons.