Workshop WS0501WM - Removing Vac from Storage Rack; Vac Removal Procedure

9
HANGING VAC ON STORAGE RACK
(continued)
Cord Storage
When your Wall Mounted Wet/Dry Vac is
not in use, it should be unplugged from
the outlet. Excess cord should be
wrapped over the hose storage rack.
Several loops may be required to
eliminate any tripping hazard created by
a loosely hanging cord.
Removing Vac from Storage
Rack
1. Unplug the power cord from the
electrical outlet. Remove the cord from
the cord retainer. Drape the loose cord
over the top of the Vac.
2. With your right hand, grasp the carry
handle.
3. With your left hand depress the release
tab located on the left side of the
storage rack.
4. Lift up on the handle, and pull the Vac
up and out of the storage rack.
Cord Retainer
Cord
SP6931-2 Workshop 5 Gallon.qxp_SP6931 8/22/16 2:03 PM Page 9