Workshop WS0501WM User Manual

8
HANGING VAC ON STORAGE RACK
5. Lower the Vac until the upper hook
and lower hook are engaged and the
bottom of the Vac canister rests on the
rack. The release tab will pop out over
the flange on the motor assembly.
6. Snap the power cord into the cord
retainer in the front surface of the rack.
The cord may exit on either the left or
right side. Plug the power cord into the
electrical outlet. Do not fasten power
cord to wall in any way.
1. Set the Vac on the floor near the
storage rack. Measure the distance
from center of storage rack to the
closest electrical outlet and add
18 inches.
2. Uncoil that amount of power cord from
the cord wrap. Drape the loose cord
over the top of the vacuum and down
the front.
3. Grasp the handle with one hand and
the bottom of the Vac canister at the
front with the other hand. Always lift the
Vac with both hands. Lift the Vac up to
the storage rack.
4. Align the upper hook on the Vac with
the rectangular opening in the storage
rack. Push the Vac against the storage
rack.
Outlet
Distance
+
18 Inches
Rectangular
Opening
Handle
Upper
Hook
Lower Hook
Release Tab
Storage Rack
Rectangular
Opening in
Storage Rack
Upper
Hook
Push
Vac
Against
Storage
Rack
Storage
Rack
Release
Tab
Upper
Hook
Lower
Hook
SP6931-2 Workshop 5 Gallon.qxp_SP6931 8/22/16 2:03 PM Page 8

Workshop WS0501WM Specifications

General

Brand	Workshop
Model	WS0501WM
Category	Vacuum Cleaner
Language	English