MAINTENANCE
12
Filter Bag
INSTALLATION INSTRUCTIONS
A Filter Bag may be used in place of or in
addition to the Qwik Lock™ Cartridge
Filter .
NOTE: When picking up dry debris a
Filter Bag or Cartridge Filter must be
properly installed.
1. Filter bag to be used to pick up dry
debris only.
2. Correct positioning of Cardboard
Collar is required to assure proper
seal.
3. Locate two Ribs on Inlet Tube, inside
Drum.
4. Slide Cardboard Collar onto Inlet Tube
and position Cardboard Collar
between the two Ribs.
5. With the Cardboard Collar securely
installed, unfold and position Filter Bag
inside Drum, as shown.
REMOVAL INSTRUCTIONS
1. Slide Cardboard Collar toward center
of Vac Drum.
2. Remove Filter Bag from Vac Drum and
discard.
3. Install new Filter Bag.
WARNING: To avoid health
hazards from vapors or dust, do not
vacuum toxic, carcinogenic or other
hazardous materials such as
asbestos, arsenic, barium,
beryllium, lead, pesticides or other
health endangering materials.
CAUTION: To avoid spilled
debris, when picking up heavy or
sharp material, monitor bag volume
and do not overfill.
!
!
Vac
Inlet Tube
Cardboard
Collar
Filter Bag
Ribs (2)
Unfolded
Filter Bag
Vac
Cardboard
Collar
SP6820-2 Workshop 2018.qxp_WS1200VA0 WS1600VA0 7/20/18 1:56 PM Page 12
To Next Page
Loading...
Need help?
General
