5.3.5 During the cleaning, the distance between the nozzle and the object
surface to be cleaned should not be too far, normally not more
than 11.81in (30cm), as the impulsive force decreases with the
increase of the distance.
• You should hold the gun trigger rmly during the cleaning.
• The safety value doesn’t control the gun during operation, but only
prevents it from opening unintentionally.
• Sprayed the human beings or electric equipment is forbidden.
• Don’t place the power wire on the road so as avoid breaking the wire.
• The nozzle used in the cleaner are supplied by our factory.
5.3.6 After the cleaning is nished, open the trigger, switch off the pump
and unplug the power cable from the mains. Close the water inlet
and detach the appliance from the water connection. Pull the trigger
until there is no more pressure in the appliance, and secured the
trigger with safety button against unintentional opening.
5.3.7 GFCI Operation Instruction:
This pressure washer is provided with a ground fault circuit inter
rupter (GFCI) built into the plug of the power supply cord. This
device provides additional protection from the risk of electric shock.
Should replacement of the plug or cord become necessary, use only
identical replacement parts that include GFCI protection.
Use only extension cords that are intended for outdoor use. These
extension cords are identied by a marking “Acceptable for use with
outdoor appliances; store indoors while not in use.” Use only exten
sion cords having an electrical rating not less than the rating of the
product. Do not use damaged extension cords. Examine extension
cord before using and replace if damaged. Do not abuse extension
cord and do not yank on any cord to disconnect. Keep cord away
from heat and sharp edges. Always disconnect the extension cord
from the receptacle before disconnecting the product from the
extension cord. Always plug the extension cord into a GFCI
protected outlet. To avoid the possibility of the tool plug getting wet
when using an extension cord, arrange a “drip loop” in the cord
connecting the pressure washer to the extension cord. The “drip
loop” is that part of the cord below the level of the connector which
prevents water travelling along the cord and coming in contact with
the connection. If the plug does get wet, DO NOT unplug the cord.
Disconnect the fuse or circuit breaker that supplies power to the
tool, then unplug and examine for presence of water in the connection.
Maintenance
AFTER SALES SUPPORT
USA
USA
High Pressure Washer
1800 505 8311 acs@americancustomerservice.com
11
WARNING: To reduce the risk of electrocution, keep all connections
dry and off the ground. Do not touch plug with wet hands.
6. Maintenance
6.1 Monthly or as required, maintenance the appliance.
6.1.1 Clean the nozzle. Remove dirt from the nozzle hole with a needle and
rinse it with water from the front.
6.1.2 Clean the strainer in the water connection. It can e easily removed
with at-nosed pliers.
6.2 Winter protection
Frost will destroy an appliance that has not been completely emptied of
water. The correct method is to separate the inlet hose from the water
supply system. Turn on the cleaner to run for about 30 seconds for water
extraction. Remove the high-pressure plastic hose to exhaust the remain-
ing water in it. The appliance had better be stored in a warm room.
To Next Page
Loading...
Need help?
General
