Cordless Reciprocating Saw · 20V Lithium-Ion Battery
9
support@merotecusa.com
1866 902 9690
AFTER SALES SUPPORT
Charging procedure
IMPORTANT: The baery pack is not fully charged at the factory. Before aempng to
charge them, thoroughly read all of the safety instrucons.
(1) To assure that the charger you use are applicable to the baery pack.
(2) Plug the charger plug into the charging hole of the baery pack.
(3) Plug the charger into any suitable standard outlet.
(4) Let the baery pack charge inially unl the green light illuminates. If all power lights are
on, the baery pack is fully charged.
Recharge discharged baeries as soon as possible aer use or baery life may be greatly di-
minished. For longest baery life, do not discharge baeries fully.
It is recommended that the baeries be recharged aer each use.
WARNING: Fire Hazard. When you unplug the output plug from the charging hole, be sure
to unplug the charger from the outlet rst, then disconnect the charger output plug from the
charging hole.
Important Charging Notes
1. Your tool was sent from the factory in an uncharged condion. Before aempng to use it,
it must be charged.
2. CAUTION: To reduce the risk of damage to the baeries, NEVER charge them in an air
temperature below 40°F (4.5°C) or above 105°F (40.5°C). Also, NEVER charge them if the
baery temperature is below 40°F (4.5°C) or above 105°F (40.5°C). Longest life and best
performance occurs when baeries are charged with an air temperature of approximately
75°F (24°C). NOTE: The tool will not charge if the tool temperature is below approximately
32°F (0°C) or above 113°F (45°C).
3. While charging, the charger may hum and become warm to touch. This is a normal occur-
Safety Instructions
charging hole
To Next Page
Loading...
Need help?
General
