10
support@merotecusa.com
1866 902 9690
AFTER SALES SUPPORT
Cordless Reciprocating Saw · 20V Lithium-Ion Battery
rence and does not indicate a problem.
4. If the baeries do not charge properly—(1) Check current at receptacle by plugging in a
lamp or other appliance. (2) Check to see if receptacle is connected to a light switch which
turns power o when you turn out the lights. (3) Move charger and tool to a surrounding
air temperature of 40°F (4.5°C) to 105°F (+40.5°C). (4) If the receptacle and temperature
are OK, and you do not get proper charging, take or send the tool and charger to your local
service center.
5. The tool should be recharged when it fails to produce sucient power on jobs which were
easily done previously. Baery life may be greatly diminished if baeries are discharged
deeply. DO NOT CONTINUE using product with its baeries in a depleted condion. Re-
charge discharged baeries promptly.
6. To maximize baery life:
a. Do not fully discharge baeries.
b. Fully recharge baeries aer each use.
c. Store tool in a locaon where the surrounding air temperature is approximately
40°F-75°F (4.5°C - 24°C).
d. Disconnect charger from tool aer charge is complete.
WARNING: Fire Hazard. When disconnecng the charger from the tool, be sure to un-
plug the charger from the outlet rst, then disconnect the charger cord from the tool.
Safety Instructions
To Next Page
Loading...
Need help?
General
