7
CUSTOMER SERVICE
UK: 0800 / 328 6020
Info@globaltronicssupport.com
GT-MM-10, 09/13, E46106
Ireland: 00800 / 4467 5888
Calibration is required again after 60 seconds, in order to reduce the
occurrence of measurement errors.
1. Hold device against the surface (selection location whether the object searched
for is very unlikely to be).
2. Keep calibration press down and do not move the device, 3 short beeping tones
confirm successful calibration.
3. Continue to keep key pressed and start search.
Note:
The calibration button must remain pressed during the entire search process
(calibration and search).
If you calibrate too closely to the object or directly on the wood, the calibration
can fail. If the calibration fails, the LC display shows the following symbol
and a long beeping tone sounds.
Please switch the device on again in order to start the calibration.
Move and hold the device several centimetres further to the right of left of the
previous surface and recalibrate.
Searching for/detecting the hidden object
After calibration, slide the device slowly and in a horizontal direction along the
wall (see illustration). Do not lift or tip the device.
The search/detection process is the same in all
4 modes and is clarified on the basis of the
illustration.
The found object must be crossed twice with the
device each time. The crossing takes place in
opposite directions.
Multi Sensor UK WORKZONE E46106.book Seite 7 Montag, 22. April 2013 1:20 13
To Next Page
Loading...
Need help?
General