12
AFTER SALES SUPPORT
t
0151 649 1500
(Charged at local rates)
www.einhell.co.uk
D
1890 946 6244
WZK 180
5
Before starting
the equipment
Notes on installing
• Check the equipment for damage which may have occurred in transit.
Report any damage immediately to the transport company which was
used to deliver the compressor.
• Install the compressor in the vicinity of the point of consumption.
• Avoid long air lines and supply lines (extension cables).
• Make sure that the intake air is dry and dustfree.
• Do not install the compressor in a damp or wet room.
• The compressor may only be used in suitable rooms (with good ven-
tilation and an ambient temperature from +5 °C to 40 °C). There must
be no dust, acids, vapors, explosive gases or inammable gases in the
room.
• The compressor is designed to be used in dry rooms. It is prohibited
to use it in damp conditions.
Mains connection
Before you use the machine, make sure that the mains voltage complies
with the specications on the rating plate. Long supply cables, extensi-
ons, cable reels etc. cause a drop in voltage and can impede motor start-
up. At low temperatures below +5°C, sluggishness may make starting
dicult or impossible.
WZK_180_UK.indb 12 21.12.11 14:38
To Next Page
Loading...
