Cordless Portable Power Cleaner EN
13
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY & OPERATION
ACTION FIGURE
BEFORE OPERATION
Installing the battery pack See Fig. A1
Removing the battery pack See Fig. A2
Charging the battery pack
More details can be found in WA3742’s
manual
See Fig. A3
OPERATION
NOTE: The power nozzle has two
working modes: short lance only and
pressure cleaning lance only.
Working mode 1
Attaching short lance to the power
nozzle
NOTE: When attaching, align the
two projections on the lance with the
grooves of the power nozzle as shown
in Fig. B.
NOTE: In this working mode, the
pressure ranges from 1.5psi to 13psi. It
is suitable for watering.
See Fig. B
Watering (working mode 1) See Fig. C
Working mode 2
Attaching pressure cleaning lance to the
power nozzle
NOTE: When attaching, align the
two projections on the lance with the
grooves of the power nozzle as shown
in Fig. D.
NOTE: In this working mode, the
highest pressure is 320psi. It is suitable
for removing strong stains.
See Fig. D
Attaching the multi-spray nozzle
NOTE: When attaching, rotating the
nozzle left and right to make sure the
nozzle fully seated into position and
gently pulling it to make sure it is
locked into position securely.
See Fig. E
Cleaning (working mode 2)
WARNING: Do not connect the
machine to water supplies
that are dirty, rusty, muddy, or
corrosive. (Including window
cleaning liquids, plant foods, or
fertilizers etc.)
NOTE: Not recommended for use
with salt water, immediately rinse with
fresh water for proper maintenance.
See Fig. F
Attaching the draw hose to the power
nozzle
NOTE: After the draw hose is attached,
check the connection by gently pulling
upon the draw hose. It should not be
pulled off.
See Fig.
G1, G2
Attaching your own water hose
(optional)
1. Attach the quick connect adapter
2. Attach the home garden hose with
suitable connectors
NOTE: Except for the draw hose
supplied, you can also connect the
power nozzle to your own water hose
with suitable connectors.
NOTE: Check whether the filter screen
is missing before retightening the
hose adapter. (Fig. S1, S2) When
retightening the hose adapter, please
tighten securely. Otherwise, it may not
draw any water for proper operation.
WARNING: It is not
recommended to connect the
draw hose to your garden hose or
your home tap.
See Fig.
H, I
Pressure setting
Your power nozzle has two pressure
modes.
See Fig. J
Start
NOTE: At the first use, you need to
empty the air in hose, place the
power nozzle below waist level (<5ft /
1.5m), then attach the extension
lance and set it at high pressure. Do not
start working until the water
goes up along the hose and sprays out.
This could take up to 30
seconds or more depending on the
fresh water source.
See Fig. K
Selecting the nozzle pattern
NOTE: Choose a suitable nozzle
pattern according to your work. Spray
patterns 0
o
, 15
o
, 25
o
and 40
o
are
applicable for cleaning, and the spray
pattern with the symbol
is best
suitable for showering.
WARNING: Do not shift the nozzle
pattern when the tool is powered on.
See Fig. L
To Next Page
Loading...
