Why won't my Worx HYDROSHOT WG625 start?
Your Worx Pressure Washer may not start due to: * The battery pack not being attached well. Reinstall the battery pack. * The battery pack being empty. Replace with a new battery pack or recharge it. * A defective battery. Replace with a new battery pack.
What to do if outlet pressure increases suddenly in my Worx HYDROSHOT WG625?
If the outlet pressure of your Worx Pressure Washer increases suddenly, it might be because the multi-spray nozzle is blocked. Replace it with a new one.
Why does my Worx HYDROSHOT WG625 Pressure Washer turn on but have no pressure?
There are several reasons why your Worx Pressure Washer might turn on but not draw water or produce sufficient pressure: * The power nozzle may be too high from the water source surface. Lower the machine below 5ft/1.5m. * The hose filter could be blocked. Take out the hose filter and rinse the parts with clean water. * The garden hose might not be well connected. Check and reattach the garden hose tightly. * The filter screen might be blocked. Clean the filter screen regularly. * The pump, hose, or other parts could be frozen. Wait for the pump, hose or other parts to thaw.
What to do if my Worx Pressure Washer stops automatically?
Your Worx Pressure Washer might stop automatically due to the following reasons: * The battery pack is empty. Replace with a new battery pack or recharge the battery pack. * The multi-spray nozzle is blocked, activating the current protection. Replace it with a new one.
Why is my Worx Pressure Washer pressure not consistent?
Inconsistent pressure in your Worx Pressure Washer can occur if additional air is being sucked into the machine. Check the connection between the hose adapter.
What to do if my Worx HYDROSHOT WG625 Pressure Washer multi-spray nozzle leaks?
If your Worx Pressure Washer multi-spray nozzle is leaking: * Ensure the nozzle pattern symbol aligns correctly, as the nozzle pattern may not spray correctly. * If the fixing nail of the multi-spray nozzle loosens, tighten it with a hex key.
Why does my Worx Pressure Washer drain water after stopping?
Your Worx Pressure Washer drains water after stopping because there is water remaining in the lance and pump. Make sure to drain all the water completely before storage.
Essential safety precautions to follow when using the product.
Critical safety guidelines specifically for the battery pack.
Initial setup procedures and checks before using the power cleaner.
Step-by-step guide for using the power cleaner and its functions.
Process for cleaning and maintaining the hose filter for optimal performance.
Procedure for cleaning and maintaining the filter screen.
General| Brand | Worx |
|---|---|
| Model | HYDROSHOT WG625 |
| Category | Pressure Washer |
| Language | English |
To Next Page
