How to fix a Worx Pressure Washer that won't start?
If your Worx Pressure Washer isn't starting when switched to the 'I' position, first ensure the power cord is properly plugged into a working socket. Check the socket and fuses, replacing them if necessary. Also, check the GFCI plug and press the reset button, as it may have been triggered.
Why won't my Worx Pressure Washer start?
If your Worx Pressure Washer machine does not start when the switch is in the 'I' position, it could be due to several reasons: * The power cord might not be properly plugged in. * The socket you are using could be defective. * The GFCI (Ground Fault Circuit Interrupter) might have been triggered.
Why is the pressure so low on my Worx WG605?
If the pressure of your Worx Pressure Washer pump is not adequate, it could be due to several factors: * Insufficient water supply. * Restricted water supply. * The diameter of the garden hose being too small. * A leak or kink in the hose.
Why is the pressure of my Worx WG605 Pressure Washer not consistent?
To address inconsistent pressure in your Worx Pressure Washer, try these steps: First, remove the nozzle and turn on the machine for a short while before reinstalling the nozzle to eliminate any air in the line. Next, check the water inlet adapter for clogs or dirt; remove it, rinse with water, and reattach. If the issue persists, it may indicate a faulty pump.
What to do if the Worx Pressure Washer pump pressure is not adequate?
If your Worx Pressure Washer pump isn't providing adequate pressure, ensure that the water supply is fully open and not restricted. Inspect the water hose for any kinks or leaks that may be limiting water flow. Also, verify that you are using a garden hose with an adequate diameter. Replace the hose or untie any kinks if necessary.
Why is my Worx Pressure Washer pressure surging?
If your Worx Pressure Washer machine pressure is not consistent, it may be due to a faulty pump, air in the line, or a clogged or dirty water inlet adapter.
What to do if Worx WG605 Pressure Washer hose is leaking?
If you notice a leak or a kink in the hose of your Worx Pressure Washer, replace the hose or untie any kinks present in it.
How to remove air from Worx WG605 line?
If there is air in the line of your Worx Pressure Washer, remove the nozzle, turn on the machine for a short period, and then reinstall the nozzle.
What to do if Worx WG605 Pressure Washer water supply is restricted?
If the water supply to your Worx Pressure Washer is restricted, check if the water hose has any kinks or leaks.
How to unclog Worx WG605 water inlet adapter?
If your Worx Pressure Washer's water inlet adapter is clogged, remove the adapter, rinse it with water, and then reattach it.
General| Power Source | Electric |
|---|---|
| Flow Rate | 1.2 GPM |
| Motor | 13 Amp |
| Weight | 15.4 lbs |
| Hose Length | 20 ft |
| Power Cord Length | 35 ft |
| Nozzle Types | 0°, 25°, 40°, Soap |
| Motor Type | Induction |
| Nozzles Included | 5 Quick-Connect nozzles (0°, 15°, 25°, 40°, soap) |
To Next Page
