10
Electric Pressure Washer EN
Turn on the water supply tap.
Connect the washer to the power
supply and turn the switch to
“I”position. Then press trigger
Note: Before pressing trigger,
Push the lock-out up and into
the trigger.
WARNING: Do not start
the machine without
connecting and
turning on the water supply
because it may cause damage
to high pressure seals and
reduce the service life of
pump.
See Fig. G1,G2
Release the trigger and turn the
switch to “O”position. Turn Off
the water supply tap
Note: When not in use, push
the lock-out down until it
clicks into the slot.
See Fig.H1,H2
Select the right nozzles
Select the suitable nozzle for
different cleaning jobs.
Nozzle 40
0
(white) is applicable
for cleaning on wooden and
other soft objects .
Turbo nozzle is applicable for
cleaning concrete, bricks and
masonry.
The soap nozzle is applicable for
soaping while other nozzles can-
not be used to do it.
WARNING: Do not
change the nozzle
pattern when the tool
is powered on.
See Fig.I
Cleaning
Begin with the nozzle 1-2ft away
from the surface and approach
with caution until it reaches the
desired position for overly close
spray may do harm to surface.
WARNING: Do not
connect the machine to
water supplies that are
dirty, rusty, muddy, or corrosive.
(Including window cleaning
liquids, plant foods, or fertilizers
etc.)
See Fig. J
Add and use detergent
Install the soap nozzle before
operation.
Note: If necessary, use a funnel
(not supplied)to prevent ac-
cidental overflows of detergent
outside of the tank.
See Fig. K1, K2, K3
MAINTENANCE
Remove plug from the socket before carrying out
any adjustment, servicing or maintenance.
Inspect the product for damaged or worn parts before each
use. Do not operate it if you find damaged or worn parts.
Contact your supplier or the manufacturer for replacement
parts.
Power cord maintenance
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard
Pump maintenance
Inspect the pump frequently whether any leaking occurs
around the pump seal. If leaking occurs, please contact
service center for repair.
Nozzle maintenance
Remove the nozzle from the lance, then remove any
possible obstructions using the included declogging needle
(See Fig. L).Then use a garden hose to rinse the nozzle by
backwashing
WARNING
Any other servicing should be performed
by an authorized service representative.
STORAGE
1. Disconnect the water source. Turn on the pressure
washers for a few seconds until the remaining water
flows out. Then turn it off quickly.
2. Unplug the power supply and wind power cord on the
lance holder. (See Fig.M)
3. Disconnect the high pressure hose and the garden hose
(not supplied) .Then wind high pressure hose on the
tool. Insert the Wand and lance separately into the Wand
Holder and lance holder. (See Fig. M)
4. Store in a frost free area with a temperature above
0
°C
(32
°
F).
To Next Page
Loading...
