Worx LANDROID L WG792E - 3. Connect the Base to the Boundary Wire

14
EN
3. Connect the base to the boundary wire
Cut the end of the wire to a length that’s appropriate
convenient for reaching the clamps.
Strip the two ends of the wire.
NOTE: Too long redundant wire may cause the signal problem.
Strip the two ends of the wire.
3.1
When connecting to the charging base there will be an
IN-wire and an OUT-wire, as shown. Connect the IN-wire
to the red clamp of the charging base and the OUT-wire to
the black clamp.
Then close the cover.
NOTE: Please fix the boundary wire around the charging
base firmly with the wire pegs.
3.2
OUT
IN
OUT
IN