Open the keypad window
by pressing the large red
button on the top of your
Landroid
®
L.
Press and hold down the
Power ON/OFF
key
until the Landroid
®
L turns on.
Input the default PIN 0000
Press the
key and close
the keypad window: your
Landroid
®
L will now find its
way to the charging base.
Watch the Landroid
®
L as it
returns to the charging base
and modify the positioning
of the boundary wire if
necessary. When the
Landroid
®
L successfully
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid
®
L will start
to fully charge.
2
• If your Landroid
®
L is
outside its territory, it
will not move and the
display will indicate
”outside working
area” error. Just move
it inside its territory and
repeat step 2.
• If your Landroid
®
L
is inside its territory
but the display says
“outside working
area”, and the LED is on,
it means you clamped
the boundary wire ends
incorrectly. Just reverse
them.
• Your Landroid
®
L should
always remain switched
on. If you ever need to
turn it off, then make
sure you place it within
its boundary area before
you switching it back on
again.
• Should your Landroid
®
L
stop operating
unexpectedly, just press
the STOP button, open
its keypad window, press
its ON/OFF key to ON,
correct the problems,
press
button, close its
keypad window.
NOTE: If your Landroid
®
L is in the charging base during a time you have programmed it to mow, then simply press the STOP
button and close keypad window to send it back to mowing.
NOTE: Please refer to the Programming and Troubleshooting Guide for more information.
Warning
To Next Page
Loading...
Need help?
General
