Keep it sharp
Always wear gloves when adjusting the blades.
The Landroid
®
M does not cut grass like other mowers. Its Blades are razor sharp on all 4 edges and
spin in both directions for maximum cutting capacity. Each blade of your Landroid
®
M has 4 cutting
edges. Depending on the frequency the Landroid
®
M mows your lawn, the cutting blades will need
to be flipped/rotated periodically for a new cutting edge. If your Landroid
®
M is programmed to mow
the lawn every day then the cutting blades will need to be rotated monthly for the best mowing
results. Each cutting blade will last up to 4 months when it is programmed to mow every day. When
the cutting blades are dull and worn out, they should be replaced with the spare blades provided with
your Landroid
®
M. Spare blades are also available at your nearest WORX retailer.
Maintenance
Your Landroid
®
M is engineered and built to stay outdoors regardless of adverse conditions. Just
periodically clean its deck from grass clipping build ups and your Landroid
®
M will mow for you
trouble-free, year after year, season after season. Donn’t wash the machine with high pressure squirt
gun. This may cause damage of the battery or the machine.
Winter storage
Even though it is tough, we would recommend that you store your Landroid
®
M in your shed or garage
during the Winter. Before storing it, give your Landroid
®
M a full recharge that will preserve its battery
from damage. You can then disconnect the plug of the charging base. A good tip to prolong the life of
the battery is to periodically re-charge it during the Winter. We'd also suggest that you cover the base
with a nylon sheet in Winter time.
Safety
Your Landroid
®
M is safe to human beings and pets. First of all, there’s a large clearance between the
outer border of the machine and the blades. Moreover, the tilt sensors will instantly stop the blades if
the unit is lifted from the ground.
Security
Your Landroid
®
M is protected by a PIN code. This PIN code prevents unauthorised people from being
able to use it. Once it’s taken outside its territory, it will not be possible to re-start it by anyone who
does not know the PIN code. This also means that you will not be able to start your Landroid
®
M if
you forget your PIN code! We strongly recommend that you write your PIN code here for future
reference. Even better, register your Landroid
®
M online at www.worxlandroid.com and record your
PIN code there. You'll be able to access your PIN code online any time.
1
3
2
4
To Next Page
Loading...
