The Landroid
®
M is running
out of the boundary wire
area. Landroid
®
M can’t
mow some area in the
marked zone, sometimes
go back or rotate when
close to this area.
The boundary wire of another Landroid
®
M or
another branded robotic mower is positioned
too closely.
Ensure your Landroid
®
M Boundary Wire has at least 2 m
of spacing between the neighboring boundary wire.
The boundary wire has been installed with
sharp corners.
Check the boundary wire to ensure the corners are
smooth.
Electric current may leak in the joint between
boundary wires due to a broken or wet
connection.
Re-wrap the joint between boundary wires to ensure a
complete and waterproof connection
There is leakage of electric current in the
wire due to a broken insulation layer.
Re-wrap the damaged insulation layer to ensure a
complete and waterproof boundary wire.
The cutting area is far more than the
declared area.
Divide your lawn to separated areas, and mow them
respectively.
Landroid
®
M wheels skid or
wheels rip the grass up.
Landroid
®
M cover is stuck by branches and
followers, which may result in skipping when
it hits obstacles.
Make sure to clear up the branches or followers inside
Landroid
®
M’s cover, and surround the branches or
followers as an island to avoid further damage.
Rain or irrigation makes the grass wet. Please mow the grass when the grass is dry.
The Landroid
®
M exits the
boundary wire due to high
speed when going down a
hill.
The Boundary Wire is placed on a slope
steeper than 15°.
Reposition the Boundary Wire away from slopes that
are steeper than 15°. Please refer installation manual for
details.
Write your PIN code here:
To Next Page
Loading...
