98
12A Electric Blower EN
98
1. HANDLE
2. ON/OFF SWITCH
3. LOWER BLOWER TUBE
4. UPPER BLOWER TUBE
5. TUBE RELEASE BUTTON
6. FAN HOUSING
7. MOTOR HOUSING
8. EXTENSION CORD RETAINER
9. POWER PLUG
TECHNICAL DATA
Rated voltage 120V~60Hz
Rated power 12A
No load speed 28600 rpm
Speed control Variable Speed
Air speed
60mph(97km/h) -
110mph(177km/h)
Airflow
320cfm(9.1m
3
/min) -
600cfm(16.9m
3
/min)
Machine weight 6.4 lbs
Protection degree
/II
OPERATION
INTENDED USE:
The blower is intended for residential use only. Use
the blower outdoors to move yard debris as needed.
ASSEMBLY AND
OPERATION
ACTION FIGURE
Assembling & disassembling the
Blower Tube
See Fig. A&B
Attaching the Extension Cord See Fig. C
Starting & Stopping
WARNING: The tool runs for
a few seconds after it has
been switched off. Let the motor
come to a complete standstill
before setting the tool down.
See Fig. D
Using the Blower
Hold the blow tube approximately
8—20cm above the ground when
operating the tool.
Use a sweeping motion from side
to side. Advance slowly keeping the
accumulated debris/leaves in front
of you.
After blowing the debris/leaves
into a pile, it is easy to dispose of
the pile.
CAUTION!
—Do not blow hard objects such as
nails, bolts, or rocks.
—Do not operate the blower near
bystanders or pets.
—Use extra care when cleaning de-
bris from stairs or other tight areas.
—Wear safety goggles or other
suitable eye protection, long pants
and shoes.
See Fig. E
Adjusting the Blowing Speed-
Variable speed
See Fig. F
STORAGE
Store the blower and extension cord indoors, in
a cool dry location, out of reach of children and
animals.
CLEANING THE TOOL
Clean the tool regularly.
WARNING! Keep your product dry.
Under no circumstances spray with water.
— To clean the tool, use only mild soap and a damp
cloth.
— Do not use any type of detergent, cleaner or
solvent which may contain chemicals that could
seriously damage the plastic.
— Self lubricating bearings are used in your
product, therefore lubrication is not required.
To Next Page
Loading...
