Hedge Trimmer WG212E
at the top. This shape will expose more of the hedge,
resulting in a more uniformed growth.
WARNING: Check extension cords before each
use. If damaged replace immediately. Never use
your tool with a damaged cord since touching the
damaged area could cause electrical shock resulting in
serious injury.
If the supply cord is damaged, it should be replaced by
a local approved Service Centre.
Take care not to expose this tool to rain.
MAINTENANCE
CLEANING
Disconnect from mains electrics supply. Using a soft
brush-remove debris from all air intakes and cutting
blade.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Wipe over surface of your Hedge trimmer with a dry
cloth.
WARNING! Never use water for cleaning your
Hedge trimmer. Do not clean with chemicals,
including petrol, or solvents as this can damage your
hedge trimmer.
LUBRICATING THE CUTTING BLADE
For easier operation and longer life, lubricate the cutting
blades before and after each use. Before lubricating,
make sure your Hedge trimmer is disconnected from
the mains electricity supply. Apply the oil so that it runs
between the two blades. (See Fig. I)
Your trimmer should be stopped, disconnected and
oiled occasionally during use.
AT THE END OF THE CUTTING SEASON
Clean your Hedge trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the Hedge trimmer for any worn or
damaged parts.
TO STORE YOUR HEDGE TRIMMER
Store the hedge trimmer in a secure, dry place out of
the reach of children. Do not place other objects on top
of the machine.
To Next Page
Loading...
