10
Cordless Hedge Trimmer  WG268E 
three sides, giving you many choices for a comfortable 
grip. Before cutting an area, inspect it first and remove 
any foreign objects that could become thrown or 
entangled in the blades.  Always hold the trimmer with 
both hands and with the blade away from you before 
turning it on. 
When trimming new growth, use a wide sweeping 
action so that the stems are fed directly into the blade. 
(See Fig. H& I)
Allow the cutting blades to reach full speed before 
cutting.  When operating, keep the cutting blades away 
from people and objects such as walls, large stones, 
trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer. Release 
the two Switch Levers (5 & 2) before attempting to clear 
jammed debris from the cutting blades. 
Wear gloves when trimming thorny or prickly growth.
Do not attempt to cut stems that are too thick for the 
cutting blade.
TOP CUTTING
Use a wide sweeping motion (See Fig. H). A slight 
downward tilt of the cutting blades in the direction of 
motion gives the best cutting results.
SIDE CUTTING 
When trimming the sides of the hedge, begin at the 
bottom and cut upwards (See Fig. I), tapering the hedge 
inward at the top. This shape will expose more of the 
hedge, resulting in a more uniformed growth.
9. CLEANING
REMOVE THE BATTERY PACK (3). Use a soft brush to 
remove debris from all air intakes and cutting blade.
Wipe the surface with a dry cloth.
WARNING: Never use water for cleaning your 
trimmer. Do not clean with chemicals, including 
petrol, or solvents as this may damage your trimmer.
LUBRICATING THE CUTTING BLADE
For easier operation and longer life, lubricate the cutting 
blades before and after each use. Before lubricating, 
make sure the battery is removed from the trimmer. 
Apply oil between the two blades periodically (See Fig. 
J). 
AT THE END OF THE CUTTING SEASON
Clean your trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the trimmer for any worn or damaged 
parts.
TO STORE YOUR HEDGE TRIMMER
The trimmer blade cover/storage holder is provided with 
2 hanging slots for storing the trimmer on the wall (See