8
Cordless Hedge Trimmer WG268E
OPERATING INSTRUCTIONS
WARNING! DO NOT USE THE PRODUCT
WITHOUT ATTACHING THE GUARD AND
FRONT HANDLE.
1. GUARD ASSEMBLY
Insert the Safety Guard (7) into the slot as illustrated in
Fig A; Use two screws to fix the guard securely.
NOTE: Make sure the Guard is firmly secured in place
2. FRONT HANDLE ASSEMBLY
The Front Handle (6) must be assembled before use:
1) Remove the bolt from the Front Handle.
2) Attach the Front Handle to the housing. Make sure
the protruding marks on the Front Handle fit perfectly
into the matching indentation on the housing. (See
Fig. B&C)
3) Insert the locking bolt into the handle and fully
tighten the bolt. (See Fig. D)
4) Check whether handle is firmly secured, if not
retighten the locking bolt.
NOTE: Make sure the handle is firmly secured in place
3. BEFORE USING YOUR CORDLESS
HEDGETRIMMER
WARNING! The charger and battery pack are
specially designed to work together so do not
attempt to use any other devices. Never insert or allow
metallic objects into your charger or battery pack
connections because of an electrical failure and hazard
will occur.
NOTE: Your battery pack is UNCHARGED and you must
charge once before use.
The battery charger supplied is matched to the Li-Ion
battery installed in the machine. Do not use another
battery charger.
4. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off
by means of a protective circuit.
In a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
5. TO REMOVE OR INSTALL BATTERY PACK (See
Fig. E)
Depress the Battery Pack Release Button (4) to remove
the Battery Pack (3) from your Hedge Trimmer. After
recharging, insert the Battery Pack into trimmer’s battery
B
C
To Next Page
Loading...
Need help?
General
