EasyManua.ls Logo

Worx WG775 - User Manual

Worx WG775
52 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
3-in-1 Cordless Lawn Mower EN
Tondeuse à Gazon Sans Fil 3 en 1 F
Cortacesped de Bateria 3 en 1 ES
P07
P21
P36
WG775
HELPLINE NUMBER
1-866-354-WORX (9679)
HELPLINE NUMBER

Table of Contents

Questions and Answers

  • O
    omarfergusonAug 14, 2025
    What to do if Worx Lawn Mower doesn’t run when Switch Safety Lever is activated?
    • P
      Peter MccallAug 14, 2025
      If the mower doesn’t run when the Switch Safety Lever is activated, check to make sure that the Safety Key has been installed and is fully seated and that the button on the switch housing is being completely pushed. If that doesn't work, release the Switch Lever to turn the mower off, remove the Safety Key, turn the mower over, and check that the blade is free to turn. If it is not free, return it to an authorized servicer.
  • M
    Melinda KeyAug 18, 2025
    Why is my Worx Lawn Mower not picking up clippings with bag?
    • E
      Elizabeth CoxAug 18, 2025
      If the mower is not picking up clippings with the bag, remove the mulch plate when bagging. Check if the chute is clogged; if so, release the Switch Lever to turn the mower off, remove the Safety Key, and clear the chute of grass clippings. If there is too much cut grass, raise the cutting height of the wheels to shorten the length of the cut. Also, ensure the bag is not full and empty it more often if needed.
  • J
    Jennifer VegaAug 21, 2025
    What to do if Worx WG775 Lawn Mower battery charger LED is not on?
    • M
      Michelle QuinnAug 21, 2025
      If the battery charger LED is not on, check the plug connection. If that doesn't solve the issue, replace the charger.
  • B
    Breanna HansenAug 25, 2025
    What to do if Worx Lawn Mower battery charger power level light does not flip to green?
    • M
      Michael SantiagoAug 25, 2025
      If the battery charger power level light does not flip to green, the battery needs to be diagnosed. Take it to an authorized service center.
  • J
    John MartinAug 28, 2025
    What to do if Worx Lawn Mower motor stops while mowing?
    • N
      nandersonAug 28, 2025
      If the motor stops while mowing: Release the Switch Lever to turn the mower off, remove the Safety Key, turn the mower over and check that the blade is free to turn. If it is not free, return it to an authorized servicer. You may also need to raise the cutting height of the wheels to the highest position and start the mower. Ensure the Battery Pack has been fully charged by plugging in the charger and waiting for the Charged Indicator Light to come on. Avoid overloading the mower by slowing down the cutting pace or raising the cut height, or both.
  • D
    denniswatsonAug 31, 2025
    What to do if Worx Lawn Mower is abnormally noisy and vibrates?
    • A
      Alicia SpencerAug 31, 2025
      If your Worx lawn mower is abnormally noisy and vibrates, release the Switch Lever to turn the mower off and remove the Safety Key. Then, turn the mower on its side and check the blade to ensure it has not been bent or damaged. If the blade is damaged, replace it. If there is no visible damage to the blade and the mower still vibrates, release the Switch Lever to turn the mower off, remove the Safety Key, and remove the blade. Rotate the blade 180 degrees and retighten. If the mower still vibrates, return it to an authorized service center.
  • S
    Stacey Willis DDSSep 3, 2025
    What to do if Worx Lawn Mower cutting performance is unsatisfactory?
    • R
      Robert HallSep 3, 2025
      If the cutting performance is unsatisfactory, release the Switch Lever to turn the mower off and remove the safety key. Turn the mower over and check the blade for sharpness, ensuring it is always sharp. Also, check the deck and discharge chute for clogging. The wheel height adjustment may be set too low for the grass condition, so try raising the cutting height.
  • A
    anthonythomasSep 7, 2025
    Why is my Worx WG775 Lawn Mower too hard to push?
    • M
      michelle30Sep 7, 2025
      If the mower is too hard to push, raise the cutting height to reduce deck drag on the grass. Also, check each wheel for free rotation.
  • X
    xlongSep 12, 2025
    Why are there clippings visible when mulching with Worx Lawn Mower?
    • V
      Vicki CannonSep 12, 2025
      If there are clippings visible when mulching, it could be due to too much cut grass. Try raising the cutting height of the wheels to shorten the length of the cut, and avoid cutting off more than 1/3 of the total length. Also, check the blade for sharpness and ensure it is always sharp.

Summary

Safety Instructions

General Safety Precautions

Essential safety guidelines applicable to all lawn mower operations.

Battery-Specific Safety

Safety rules pertaining to battery-powered lawn mowers.

Safe Practices for Walk-Behind Mowers

General Operation

Instructions for the general operation of walk-behind lawn mowers.

Operation

Starting and Stopping

Guide to starting and stopping the lawn mower.

Installing Mulch Plug

Removing Mulch Plug

Trouble Shooting

Mower Doesnt Run

Solutions for when the mower fails to start.

Motor Stops While Mowing

Troubleshooting steps for when the motor stops unexpectedly.

Unsatisfactory Cutting Performance

Mower Too Hard to Push

Abnormally Noisy and Vibrates

Worx WG775 Specifications

General IconGeneral
TypeCordless Lawn Mower
Voltage20V
Battery TypeLithium-ion
Power SourceBattery
Cutting Height Positions3
Deck MaterialPlastic
Grass CollectionRear bag
Warranty3 years
Cutting Width14 inches

Related product manuals