9
3-speed Workshop Blower
WX094
WX094.X
COMPONENT LIST
1. BLOWER TUBE
2. INTERFACE
3. BLOWER TUBE CONNECTOR
4. AIR INLET
5. ONOFF SWITCH
6. VARIABLE SPEED DIAL
7. HANDLE
8. BATTERY PACK RELEASE BUTTON *
9. BATTERY PACK *
* Not all the accessories illustrated or described
are included in standard delivery.
TECHNICAL DATA
Type WX094 WX094.X (09 - designation of ma-
chinery, representative of Cordless Blower
WX094 WX094.X**
Voltage 20V Max***
No load speed
I: 11000/min
II: 15000/min
III: 18000/min
Air volume
I: 1.6 m
3
/min
II: 2.2 m
3
/min
III: 2.8 m
3
/min
Blow speed 257km/h
Machine weight (bare tool)
1.3kg
**X=1-999, A-Z, M1-M9 there are only used for differ-
ent customers, there are no safe relevant changes
between these models.
*** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
Category Type Capacity
20V Battery
WA3551 2.0 Ah
WA3551.1 2.0 Ah
WA3553 4.0 Ah
WA3556 5.0 Ah
WA3641 6.0 Ah
20V Charger WA3880 2.0 A
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATION
Read the operator’s manual
INTENDED USE
The blower is intended for residential use only. Use the
blower outdoors to move yard debris as needed.
NOTE
• Remove the battery pack before carrying out
any adjustment, servicing or maintenance.
• Make sure that ON/OFF Switch is on ‘’O’’
position before assembling or removing any
accessories.
ASSEMBLY AND OPERATION
ACTION FIGURE
ASSEMBLY
Assembling the blower tube
See Fig A1,
A2
BEFORE OPERATION
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use. More details can
be found in charger’s manual
WARNING! The charger and
battery pack are specially
designed to work together, so do not
attempt to use any other devices. Never
insert or allow metallic objects into your
charger or battery pack connections
because of an electrical failure and
hazard will occur.
See Fig. B