13
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The power tool is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
ACTION FIGURE
Before operation
Charging the Battery
NOTE:
1. Maximize Battery Performance Prior
to initial use, the battery must be
charged 5 hours to fully utilize the
battery capacity.
2. When the battery is full charged, the
light turns green.
See Fig. A
Assembly and adjustment
Selecting the Proper Bit See Fig. B
Inserting and Removing bits See Fig. C
Forward/reverse/lock
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it is
stopped!
See Fig. D1,
D2, D3
Adjust the Extended Shaft Position See Fig. E, F
Operation
Operating the On/Off Switch
WARNING: Do not operate for
long periods at low speed
because excess heat will be produced
internally.
See Fig. G
LED Light Indicator See Fig. G
MAINTENANCE
Your power tool requires no additional lubrication or
maintenance. There is no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of
dust. If you see some sparks flashing in the ventilation
slots, this is normal and will not damage your power tool.
ENVIRONMENTAL PROTECTION
This product has been marked with a symbol
relating to removing electric and electronic
waste. This means that this product shall not be
discarded with household waste but that it shall be
returned to a collection system which conforms to the
European Directive 2012/19/EU. It will then be recycled
or dismantled in order to reduce the impact on the
environment. Electric and electronic equipment can be
hazardous for the environment and for human health
since they contain hazardous substances.
To Next Page
Loading...
