Worx WX252 User Manual

14
EN
MAINTENANCE
Your power tool requires no additional lubrication or maintenance. There is no
user serviceable parts in your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean. Keep all working
controls free of dust. If you see some sparks flashing in the ventilation slots, this
is normal and will not damage your power tool.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authorities or
retailer for recycling advice.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage of tool and battery is
0℃-45℃.
The recommended ambient temperature range for the charging system during
charging is 0℃-40℃.
TROUBLE SHOOTING
Problem Possible cause Solution
Battery will not
charge
1. Charger not
plugged into a
working outlet.
2. Surrounding air
temperature is too
hot or too cold
1. Plug charger into a working outlet.
Check current by plugging in a lamp.
2. Move charger to an appropriate
place which temperature is suitable
for the charger.
Switch cannot be
pressed
Forward/Reverse
switch at middle
position
Make sure switch is on Forward
or Reverse rotation according to
project need.
XTD Driver stops
during driving
screws
XTD Driver battery is
out of power
Make sure XTD Driver is fully charged
before using it.

Worx WX252 Specifications

General

Power source	Battery
Charging time	5 h
Battery voltage	4 V
Battery capacity	1.5 Ah
Torque (max)	3 N⋅m
Idle speed (max)	230 RPM
Reverse	Yes
Handle shape	Pistol handle
Product type	Power screwdriver
Product color	Black, Orange, Silver
Chuck diameter	-
Adjustable speed	No

Weight and Dimensions

Depth	60 mm
Width	160 mm
Height	230 mm
Weight	700 g