29
TROUBLE SHOOTING
Problem Possible cause Solution
Battery will not charge 1. Charger not plugged into a
working outlet.
2. Surrounding air temperature is too
hot or too cold.
1. Plug charger into a working outlet.
Check current by plugging in a lamp.
2. Move charger to an appropriate place
which temperature is suitable for the
charger.
Switch cannot be pressed Forward/Reverse switch at middle
position
Make sure switch is on Forward or
Reverse rotation according to project
need.
Driver stops during driving screws Driver battery is out of power Make sure the driver is fully charged
before using it.
Bit Cartridge will not rotate when Cover
slides.
The cover is not fully open Make sure the Cover is fully open and
past the red line on the tool.
Positec Australia Pty Limited
10 Corporate Blvd Bayswater , VIC 3153, Australia
To Next Page
Loading...
