10
Cordless Impact Driver WX291 WX291.X
emission value have been measured in accordance with a
standard test method and may be used for comparing one
tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways in which
the tool is used especially what kind of workpiece is
processed dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
This tool is intended for the fastening and loosening of
bolts, nuts and various threaded fasteners. This tool is not
intended for use as a drill.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Removing the battery pack See Fig. A1
Charging the battery Pack See Fig. A2
Installing the battery pack See Fig. A3
ASSEMBLY AND ADJUSTMENT
Assembling the Belt Hook and Bit Clip
See Fig. B1,
B2, B3, B4
Inserting the Bits See Fig. C1
Removing the Bits See Fig. C2
Forward / Reverse / Lock
WARNING Never change the
direction of rotation when the
chuck is rotating, wait until it is
stopped!
See Fig. D1,
D2, D3
OPERATION
Operating the On/Off Switch
WARNING Do not operate for
long periods at low speed
because excess heat will be
produced internally.
See Fig. E
To Next Page
Loading...
Need help?
General
