11
Cordless Impact Driver WX291 WX291.X
LED Light Indicator
Before operation, the light will be
activated when the On/Off switch is
slightly depressed, and will automatically
turn off 10 seconds after the On/Off
switch is released.
The tool and battery are equipped with a
protection system. The Light will quickly
flash (approximately once a second,
and stop flashing when you release the
trigger), the system will automatically cut
off power to the tool to extend battery
life. The tool will automatically stop
during operation if the tool and/or battery
are placed under one of the following
conditions:
• Overloaded: The tool is operated
in a manner that causes it to draw an
abnormally high current. In this situation,
release the Trigger Switch on the tool
and stop the application that caused the
tool to become overloaded. Then pull the
Trigger Switch again to restart.
• Overheated: Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In this
situation, let the Tool and Battery cool
before pulling the Trigger Switch again.
• Low battery voltage: The remaining
Battery capacity is too low and the tool
will not operate. In this situation, remove
and recharge the Battery.
WARNING To turn on the light,
press the On/Off switch and make
sure the Forward/Reverse Rotation
Control is on right/left position.
See Fig. E
TROUBLE SHOOTING
1. I CAN NOT FIT THE BATTERY INTO THE BATTERY
CHARGER. WHY?
The battery can be inserted into the charger only in one
direction. Turn the battery around until it can be inserted
into the slot.
2. REASONS FOR DIFFERENT BATTERY PACK WORKING
TIMES
Charging time problems, as above, and having not used a
battery pack for a prolonged time will reduce the battery
pack working time. This can be corrected after several
charge and discharge operations by charging & working
with your drill. Heavy working conditions such as large
screws into hard wood will use up the battery pack energy
faster than lighter working conditions. Do not re-charge
your battery pack below 0
o
C and above 40
o
C as this will
affect performance.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage
of tool and battery is 0
o
C-45
o
C.
The recommended ambient temperature range for the
charging system during charging is 0
o
C-40
o
C.
Positec Australia Pty Limited
10 Corporate Blvd Bayswater , VIC 3153, Australia
To Next Page
Loading...
Need help?
General
