LED LIGHT INDICATOR
Before operation, the LED light will be activated when the On/Off switch
is slightly depressed, and will automatically turn off 20 seconds after the
On/Off switch is released.
The tool and battery are equipped with a protection system. When the
LED Light is quickly flashing 3 seconds and turn off, the system will
automatically cut off power to the tool to extend battery life. The tool will
automatically stop during operation if the tool and/or battery are placed
under one of the following conditions:
• Overloaded: The tool is operated in a manner that causes it to draw
an abnormally high current. In this situation, release the Trigger Switch
on the tool and stop the application that caused the tool to become
overloaded. Then pull the Trigger Switch again to restart.
• Overheated: Under the condition above, if the tool does not start, the
Tool and Battery are overheated. In this situation, let the Tool and Battery
cool before pulling the Trigger Switch again.
• Low battery voltage: The remaining Battery capacity is too low and the
tool will not operate. In this situation, remove and recharge the Battery.
WARNING: To turn on the light, press the On/Off switch and make
sure the Forward/Reverse Rotation Control is on right/left position.
See Fig. E
TROUBLE SHOOTING
1. I CAN NOT FIT THE BATTERY INTO
THE BATTERY CHARGER. WHY?
The battery can be inserted into the charger
only in one direction. Turn the battery around
until it can be inserted into the slot, the red
LED Light should turn on when the battery is
charging.
2. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and
having not used a Battery Pack for a
prolonged time will reduce the Battery Pack
working time. This can be corrected after
several charge and discharge operations by
charging & working with your drill. Heavy
working conditions such as large screws
into hard wood will use up the Battery Pack
energy faster than lighter working conditions.
Do not re-charge your Battery Pack below
0
o
C and above 30
o
C as this will affect
performance.
MAINTENANCE
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free
of dust. Occasionally you may see sparks
through the ventilation slots. This is normal
and will not damage your power tool.
To Next Page
Loading...
Need help?
General
