Wren INFRAMED KITCHEN - Page 6

BASE UNIT
Inframed kitchen Base Guide
For Internal Use: WKIN00289_Inframed_Kitchen_Guide_Rev3
Page 6
Step 4.
Attach packer pieces to the end of the unit using 2 x 20mm countersunk screws.
Packer pieces are the same height as the unit.
Make sure that the screw head is fully ush with the surface of the packer piece. Be
careful not to insert the screw too far as it will protrude into the unit.
(This step is not required if a built in dishwasher is at this side of the unit -
See Customer Specic Kitchen Plan for details)
Step 3.
Cut decor panel to size.
Height of the decor end panel will be the height of the unit including legs + 30 and will be the same height as
the end rails. (This step is not required if a built in dishwasher is at this side of the unit - See Customer
Specic Kitchen Plan for details)