What to do if wsm L2800 engine overheated?
If your wsm Tractor engine is overheating, you can try the following: Replenish coolant, change or adjust, replenish coolant, clean, clean or replace, clean or replace, replace, loosen the load, replace, adjust, use the specified fuel.
What to do if wsm L2800 starter does not run?
If the starter on your wsm Tractor isn't running, try these solutions: Charge the battery, repair or replace the starter, repair or replace the solenoid switch, repair or replace the wiring, replace the starter motor, connect the wiring, connect the wiring.
What to do if wsm L2800 Tractor has deficient output?
If your wsm Tractor has deficient output, you can try the following: Adjust, repair or replace, repair or replace the injection pump, repair or replace the nozzle, replace head gasket, tighten cylinder head bolt, glow plug and nozzle holder.
What to do if wsm L2800 has low oil pressure?
If your wsm Tractor has low oil pressure, you can try the following: Replenish, clean, clean, replace, replace, replace, replace, clean, use the specified type of oil, repair or replace.
What to do if wsm L2800 Tractor has either black or dark gray exhaust gas?
If you observe either black or dark gray exhaust gas from your wsm Tractor, you can try the following: Lessen the load, use the specified fuel, change, clean or change, repair or replace the nozzle.
What to do if wsm L2800 has either white or blue exhaust gas?
If you observe either white or blue exhaust gas from your wsm Tractor, you can try the following: Reduce to the specified level, repair or replace, adjust, adjust top clearance.
What to do if wsm Tractor has excessive lubricant oil consumption?
If your wsm Tractor is experiencing excessive lubricant oil consumption, consider the following: Shift ring gap direction, replace, replace the piston, replace.
What to do if wsm L2800 has fuel mixed into lubricant oil?
If fuel is mixed into the lubricant oil of your wsm Tractor, you can try the following: Replace pump element or pump, repair or replace the nozzle, replace.
What to do if wsm L2800 has high oil pressure?
If your wsm Tractor has high oil pressure, you can try the following: Use the specified type of oil, replace.
What to do if wsm L2800 has water mixed into lubricant oil?
If water is mixed into the lubricant oil of your wsm Tractor, you can try the following: Replace, replace.
General| Engine Power | 28 hp |
|---|---|
| Drive | 4WD |
| Engine Type | Diesel |
| Transmission | Hydrostatic |
| Hydraulic System | Open Center |
| Type | Tractor |
| Fuel Tank Capacity | 6.6 gal |
To Next Page
