wsm M108S - User Manual

Questions and Answers

C
Catherine HernandezAug 21, 2025
Why is my wsm M108S either black or dark gray exhaust gas observed?
- E
  Erika NielsenAug 21, 2025
  If you notice black or dark gray exhaust gas from your wsm Tractor, it could be due to several reasons. You might be overloading the engine, so try reducing the load. It could also be caused by using low-grade fuel, so switch to the specified fuel. A clogged fuel filter or air cleaner could also be the culprit; in this case, replace the fuel filter or clean/replace the air cleaner. Finally, deficient injection may be the reason, so repair or replace the injector.
K
Karla BlackAug 23, 2025
What to do if wsm M108S Tractor engine overheated?
- E
  Erika TaylorAug 23, 2025
  If your wsm Tractor engine is overheating, several factors could be responsible. First, check the engine oil and coolant levels and replenish if insufficient. Inspect the fan belt for breakage or elongation and replace or adjust as necessary. Clean any dust from the radiator net and fins. If the inside of the radiator or coolant flow route is corroded, clean or replace the affected parts. A defective radiator cap should be replaced. Reduce the load if you are overload running. Replace the head gasket if defective, and ensure you are using the specified fuel.
L
lisa60Aug 26, 2025
Why wsm Tractor starter does not run?
- D
  David DavenportAug 26, 2025
  If the starter on your wsm Tractor isn't running, it could be due to a discharged battery (charge or replace it), a malfunctioning starter (repair or replace it), a malfunctioning key switch (replace it), or disconnected wiring (connect it).
C
Cassandra AdamsAug 27, 2025
What to do if wsm M108S Tractor engine revolution is not smooth?
- H
  huntermichaelAug 27, 2025
  If your wsm Tractor's engine revolution isn't smooth, it could be due to a clogged or dirty fuel filter (replace it) or a clogged air cleaner (clean or replace it). A fuel leak due to a loose injection pipe retaining nut could also be the cause; tighten the retaining nut. Other potential causes include a malfunctioning supply pump (repair or replace it), a stuck or clogged injector (replace it), or a worn or bent turbocharger. If the turbocharger is faulty, replace the turbocharger assembly.
D
Derek PettyAug 30, 2025
Why wsm M108S Tractor has deficient output?
- S
  Sharon GatesAug 30, 2025
  If your wsm Tractor is showing deficient output, it might be because the engine’s moving parts seem to be seizing (repair or replace them), the supply pump is malfunctioning (repair or replace it), or there is deficient injection (replace the injector). Other possible causes include a compression leak (check the compression and repair), a gas leak from the exhaust system (repair or replace), an air leak from the compressor discharge side (repair or replace), a dirty or clogged air cleaner (clean or replace), or a compressor wheel that does not turn freely (replace the turbocharger assembly).
W
wpattonSep 1, 2025
What to do if wsm M108S Tractor has low oil pressure?
- J
  Joshua OsborneSep 1, 2025
  If your wsm Tractor has low oil pressure, it could be due to several reasons: the engine oil level may be insufficient, so replenish it. The oil strainer might be clogged, so clean it. A relief valve could be stuck with foreign matter, so clean it, or the relief valve spring might be weak or broken, so replace it. Other causes include excessive oil clearance of the crankshaft bearing, crankpin bearing, or rocker arm, all of which would require replacement. Additionally, the oil passage could be clogged (clean it), you might be using a different type of oil (use the specified type), or the oil pump could be defective (replace it).
E
Elizabeth PalmerSep 3, 2025
Why is wsm M108S either white or blue exhaust gas observed?
- J
  johnrussellSep 3, 2025
  If you're seeing white or blue exhaust gas from your wsm Tractor, it could be due to excessive engine oil (reduce to the specified level) or worn or stuck piston rings and cylinders (repair or replace).
A
Amanda WagnerSep 6, 2025
What causes excessive engine oil consumption in wsm M108S?
- M
  maynardrebeccaSep 6, 2025
  Excessive engine oil consumption in your wsm Tractor could be caused by several factors. The piston ring's gap might be facing the same direction (shift the ring gap direction), the oil ring might be worn or stuck (replace it), the piston ring groove might be worn (replace the piston), the valve stem and valve guide might be worn (replace them), or the crankshaft bearing and crank pin bearing might be worn (replace them). Additionally, oil could be leaking due to defective seals or packing (replace them).
L
Lori WatsonSep 8, 2025
Why wsm Tractor has high oil pressure?
- D
  Doris MartinezSep 8, 2025
  High oil pressure in your wsm Tractor could be due to using a different type of oil (use the specified oil) or a defective relief valve (replace it).
B
Bradley GreenSep 10, 2025
What causes oil leak into exhaust pipe or suction pipe in wsm M108S?
- D
  Donna BrownSep 12, 2025
  An oil leak into the exhaust or suction pipe of your wsm Tractor could be due to a clogged or deformed waste oil pipe (repair or replace it) or a faulty turbocharger’s piston ring seal (replace the turbocharger assembly).