wsm M108S - Wheel Hub; Tire Pressure

G-69
M108S, WSM
G GENERAL
[3] WHEEL HUB
W1043392
[4] TIRE PRESSURE
CAUTION
• Do not attempt to mount a tire. This should be done by a qualified person with the proper equipment.
IMPORTANTQ
• Do not use tires larger than specified.
• When you intend to mount different size of tires from equipped ones, consult your distributor about front
drive gear ratio for detail.
• Excessive wear of tires may occur due to improper gear ratio.
Through the tire pressure is factory-set to the prescribed level, it
naturally drops slowly in the course of time. Thus, check it every day
and inflate as necessary.
To inflate the wheel tires, use an air compressor or hand pump.
Q Recommended Inflation Pressure
• Maintain the pressure shown below for normal use.
NOTEQ
• Maintain the maximum pressure in front tires, if using a front
loader of when equipped with a full load of front weights.
W1027488
Front wheel hub Rear wheel hub
Screw circle diameter
(A)
203.2 mm (8 in.) 203.2 mm (8 in.)
Number of screws 8 8
Screws M16 x P1.5 M16 x P1.5
Hub pilot diameter (B) 152.4 mm (6 in.) 152.4 mm (6 in.)
Tire sizes Inflation pressure
Front
9.5 L - 15 250 kPa (2.5 kgf/cm
2
, 36 psi)
10.00 - 16, 6PR 220 kPa (2.2 kgf/cm
2
, 32 psi)
12.4 - 24, 6PR 170 kPa (1.7 kgf/cm
2
, 24 psi)
13.6 - 24, 6PR 150 kPa (1.5 kgf/cm
2
, 22 psi)
13.6R24 160 kPa (1.6 kgf/cm
2
, 23 psi)
Rear
16.9 - 34, 6PR 120 kPa (1.2 kgf/cm
2
, 18 psi)
18.4 - 34 140 kPa (1.4 kgf/cm
2
, 20 psi)
18.4R34 120 kPa (1.2 kgf/cm
2
, 18 psi)
18.4-30 110 kPa (1.1 kgf/cm
2
, 16 psi)
18.4R30 110 kPa (1.1 kgf/cm
2
, 16 psi)
(A) Insufficient
(B) Standard
(C) Excessive
(D) Ground
KiSC issued 05, 2012 A