EasyManuals Logo

WTC Technitron T2050 User Manual

WTC Technitron T2050
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
49@CgYdSXUc
& =_TYVYUT*(! % ! DUSX^Ydb_^D" % GU \T3_^db_\
Figure 349@CgYdSXUcF! !1
4Yc`\Qi-')
Anyone skilled in EPROM reproduction can configure the
features of any T2050 by applying the features of the virtual
switches listed on the next page.
79DQG96ZLWFK
2SWLRQVDW(3520/RFDWLRQ
(DIP switch or Network download control of firmware V1.00
features) (normal)=set in firmware V1.01 displaying 77.
(3520/RFDWLRQ 1RUPDO
Hardware SW1 Switch is Enabled
Option Flag at EPROM $0206 is Enabled
Host "SW1H" Downloadable Parameter is Disabled
Host "OPTFLGH" Downloadable Parameter is Disabled
(3520/RFDWLRQ 
Hardware SW1 Switch is Disabled (SW1 may be removed)
Option Flag at Eprom $0206 is Disabled
Host "SW1H" Downloadable Parameter is Enabled (Host control
of SW1)
Host "OPTFLGH" Downloadable Parameter is Enabled (Host
control of Option)
C = ACCESS YELLOW CONFIG
C = BINARY VALVES
C = DISPLAY SCHEDULE
C = HYPERSIL WELD TRANS.
C = RESET FAULT BY PILOT
C = PS/SS RESETS STEPPER
C = BINARY INITIATION
C = CONSTANT CURRENT
0 = ACCESS YELLOW DENIED
0 = DISCRETE VALVES
0 = DISPLAY LAST CURRENT
0 = STACKED IRON WELD TRANS.
0 = FAULT NOT RESET BY PILOT
0 = SECOND STAGE
0 = DISCRETE INITIATION
0 = AVC MODE WELD
8
7
6
5
4
3
2
1
Closed
Open

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WTC Technitron T2050 and is the answer not in the manual?

WTC Technitron T2050 Specifications

General IconGeneral
BrandWTC
ModelTechnitron T2050
CategoryControl Unit
LanguageEnglish

Related product manuals