24
Service, Maintenance, Transportation and Storage
The welder needs regular maintenance as following: Periodically clean dust, dirt, grease, etc. from your
welder. Every six months, or when necessary, remove the welder cover panel and air-blow any dust
and dirt that may have accumulated inside the welder. Replace power cord, ground cable, ground
clamp, or electrode assembly when damaged or worn.
MINOR AND ROUTINE MAINTENANCE
Store in a clean dry facility, free from corrosive gas, excess dust and high humidity. Temperature
range should be -12
o
C to +50
o
C and the relative humidity not more than 90%.
When transporting or storing the welder after use, it is recommended to repack the product as it was
received in order to protect it. (Cleaning is required before storage and you need to seal the plastic
bag in the cardboard box before storage).
EC Declaration of Conformity
We declare under our sole responsibility that this product is in conformity with the following standards
and standardization documents:
EN 60974- 1:2012, EN 60974-10:2007 in accordance with the directives: 2006/95/EC,
2004/108/EC.
Technical documentation at:
Würth Hellas SA
23rd Km Athens-Lamia National Road
145 68 Krioneri Attica
Greece
D. Assimosis
General Manager
To Next Page
