To Next PageTo Next Page
Need help?Do you have a question about the Würth EWS 14-125-EQ Universal and is the answer not in the manual?
General| Power | 1400 W |
|---|---|
| Disc Diameter | 125 mm |
| Spindle Thread | M14 |
| Cable Length | 4 m |
| No-load Speed | 11500 RPM |
Details the hazard levels: DANGER!, WARNING!, CAUTION!, and Attention!.
Explains the structure of DANGER warnings: type, consequences, and prevention.
Tool is for grinding, sanding, wire brush, cut-off. Follow all safety instructions.
Wear appropriate PPE like face mask, goggles, gloves, apron for protection from flying debris and noise.
Do not allow tool to run while carrying; clean ventilation slots; avoid flammable materials; do not use liquid coolants.
Hold tool firmly to absorb recoil forces; use auxiliary handle for control.
Never put hands near a rotating attachment as it can travel over your hand during recoil.
Use only approved grinding wheels and safety hoods for the electric tool.
Securely fit and adjust safety hood for maximum security, protecting from broken pieces and sparks.
Avoid blocking cut-off wheel or excessive pressure; deep cuts increase risk of recoil or breakage.
Wear safety goggles; use flexible underlays; observe accessory manufacturer's instructions.
Details health hazards from various dusts and recommended protective measures.
Do not machine materials emitting health-endangering dusts/vapours; ensure ventilation openings remain free.
Tool is for grinding, sanding, wire brush, cut-off; not for polishing; warranty voided if used improperly.
Warns that noise levels may exceed 80 dB(A), risking severe injuries and acoustic trauma. Wear ear protectors.
CAUTION: Risk of severe injuries. Work only with the auxiliary handle attached firmly.
CAUTION: Risk of severe injuries. Use only the safety hood intended for the grinding wheel.
Press and hold lever, push hood onto spindle, adjust position, ensure closed side faces operator, check engagement.
WARNING: Risk of severe injuries. Pull mains plug before all tooling operations.
WARNING! Always guide machine with both hands. First switch on, then contact workpiece.
Attention! Always work up-milling mode. Work with moderate feed, do not tilt, press, or oscillate.
WARNING! Danger of electric current. Carry out work only when the mains plug has been removed.
