2
1Electrodes
2Suction hose
3 Air outlet, working air
4Suction head lock
5 Air inlet, motor cooling air
6Suction head
7 Dirt receptacle
8Impeller
9 Steering roller bow
10 Steering roller
11 Floor nozzle
12 Suction pipe
13 Suction support
14 Cable hook
15 Filter cover
16 Carrying handle
17 Push handle
18 Bender
19 Rotary switch for suction output (min-max)
20 Automatic remote start
21 Socket
22 Automatic filter dedusting
23 Main switch
24 Flat fold filter
25 Filter dedusting
26 Floor nozzle holder
27 Drain hose
28 Holder for suction pipes
29 Holder for crevice nozzle
30 Power cord
31 Nameplate
Caution
The flat pleated filter must must always
be in place while vacuuming.
– When vacuuming fine dust, you may also use
an additional paper filter bag or a membrane
filter (special accessory).
Illustration
Release and remove the suction head.
Insert the paper filter bag or the membrane fil-
ter (special attachment).
Insert and lock the suction head.
Illustration
Remove the brush strips.
Install the rubber lips.
Note: The structured side of the rubber lips must
point outwards.
– If the appliance is used to vacuum wet dirt the
paper filter bag or the membrane filter (special
accessory) must always be removed.
– It is recommended to use a special filter bag
(wet).
ISS 55 automatic, ISS 55-S automatic on-
ly:
Illustration
Drain off dirty water through the drainage
hose.
Device elements Start up
Dry vacuum cleaning
Inserting the paper filter bag
Wet vacuum cleaning
Inserting the rubber lips
Remove the paper filter bag
Drain off dirt water
14
To Next Page
Loading...
