To Next PageTo Next PageWhy is there no gas from Würth Welding System?
If your Würth Welding System is not providing gas, the gas hose may be blocked, so connect the gas. The gas hose might also be pressed, so check the gas flow. The electropneumatic valve could be broken, requiring repair or replacement. Alternatively, the control board might be broken, needing repair or replacement.
How to prevent slag inclusion with Würth Welding System?
If you notice slag inclusion while using the Würth Welding System, it could be because the former molten slag of the welding bead wasn't cleaned; remove the molten slag. Also, a small current, too much weld deposition, or excessive swing during welding could be the cause; increase the current and reduce the swing during welding.
Why is power supply tripping with Würth Welding System?
If the power supply is tripping when using the Würth Welding System, and the power has been off for more than 2 days and you're powering it on for the first time, it is not a failure; the main circuit gets power and trips, so close the switch. If tripping occurs during welding operation, contact the seller.
Why is machine or cable is over heating on Würth Welding System?
If you're experiencing overheating in the machine or cable, or if the “+” or “-” socket is overheating on your Würth Welding System, the torch power might be too small, so change to a bigger power torch. The cable might also be too small in diameter, so change to a suitable cable. A loose socket could also be the issue, so remove any scale cinder and properly connect the socket.
General| Output Current Range | 30-350 A |
|---|---|
| Wire Diameter Range | 0.6 - 1.2 mm |
| Type | MIG/MAG |
| Welding Process | MIG/MAG |
| Input Voltage | 3 x 400 V |
| Duty Cycle | 60% at 350 A |
